Flowering Shrubs

How to Plant a Shrub: Hole Size, Depth and Aftercare

How to plant a shrub so it establishes well: when to plant, how wide and deep to dig, whether to add compost, and how to water and mulch in the first year.

On this page
  1. Quick steps
  2. When to plant shrubs
  3. Choosing the spot and spacing
  4. Preparing the soil
  5. How big a hole?
  6. How deep to plant
  7. Step by step: planting a container shrub
  8. Planting bare-root and root-balled shrubs
  9. Should you add compost or fertiliser to the hole?
  10. Staking
  11. Watering and aftercare in the first year
  12. Special cases

Quick steps

  1. Plant in autumn if you can, or in spring, when the soil is moist and not frozen.
  2. Water the shrub well in its pot before planting.
  3. Dig a hole two to three times as wide as the root ball but no deeper than it.
  4. Loosen the soil at the base and sides of the hole.
  5. Tease out circling roots.
  6. Set the shrub so the top of the root ball is level with the soil surface.
  7. Backfill with the soil you dug out and firm gently.
  8. Water thoroughly, then mulch, keeping the mulch off the stems.
  9. Keep watering in dry spells through the first year or two.

The rest of this guide explains each step.

When to plant shrubs

  • Container-grown shrubs can be planted at any time of year if the ground isn’t frozen or waterlogged. Autumn is usually best: the soil is still warm, rain is more reliable, and roots can grow before the plant has to support summer leaves.
  • Spring is a good second choice, and is better for slightly tender or grey-leaved shrubs such as hardy fuchsias, lavender and cistus, which establish better before their first winter if planted in spring or early summer.
  • Summer planting is possible, but you’ll need to water much more often.
  • Bare-root shrubs (often hedging plants and roses) are sold and planted in the dormant season, roughly November to March.

Choosing the spot and spacing

  • Check the label for the shrub’s final height and spread and its preferred light and soil.
  • Space shrubs so that, when fully grown, they will just touch their neighbours. If that leaves gaps for a few years, fill them with perennials or bulbs.
  • Plant at least half the expected spread away from walls, fences and paths, plus a bit more for access. Soil at the base of a wall is often dry because the wall keeps rain off.

Preparing the soil

  • Remove perennial weeds, particularly roots of bindweed, couch grass and ground elder, before you plant.
  • If the soil is compacted, dig over a wide area, not just the planting hole.
  • On very poor or sandy soil, you can work some well-rotted organic matter into the general area. This works better than putting it only in the hole.

How big a hole?

Wide, not deep. Dig a hole roughly two to three times the width of the root ball. Most new roots grow outwards through the top layer of soil, so loosening a wide area helps them spread.

Then:

  • Break up the base of the hole lightly with a fork, without digging it any deeper.
  • Roughen the sides of the hole, particularly on clay. Smooth, spade-cut sides can act like the wall of a pot, and roots may circle rather than grow out.

On heavy clay, take care not to create a sump. A deep hole filled with loose, rich material can collect water from the surrounding clay and drown the roots. A wide, shallow hole, or planting on a slight mound, helps prevent this.

How deep to plant

Plant so the top of the root ball is level with the surrounding soil surface. Where the stems meet the roots, the plant should be at the same depth as it was in the pot. On heavy, wet soils, setting it very slightly higher, by a centimetre or two, can help, as the plant may settle.

Planting too deeply is one of the most common causes of poor growth and slow decline in shrubs. Buried stems can rot, and roots deep in the soil may lack oxygen. To check the depth, lay a cane across the hole and see where the top of the root ball sits against it.

Exceptions: A few shrubs are deliberately planted deeper. The main example is hardy fuchsias, which are planted a few centimetres below the surface so the buried stems can resprout after a hard winter. See our hardy fuchsia guide. Some clematis are also planted deeper, but most shrubs should go in at their original depth.

Step by step: planting a container shrub

  1. Soak the root ball. Water the shrub thoroughly in its pot an hour or so before planting, or stand the pot in a bucket of water until bubbles stop rising.
  2. Dig the hole wide and no deeper than the root ball, as above.
  3. Remove the pot. Turn the plant on its side and slide it out. If it’s stuck, squeeze the pot or cut it away.
  4. Tease out the roots. If roots are circling tightly around the root ball, gently tease them out with your fingers. Badly pot-bound plants can have a few shallow vertical cuts made down the sides of the root ball to encourage new roots. Daphnes and other shrubs with fragile roots should be handled very gently instead.
  5. Position the shrub. Set it in the hole at the right depth, with its best side facing the way you’ll usually see it.
  6. Backfill. Return the soil you dug out, breaking up any lumps. Firm gently with your hands or the sole of your boot to remove large air pockets, without compacting it hard.
  7. Water well. Give a generous soaking, roughly a full watering can for a medium-sized shrub, so the water reaches the bottom of the root ball.
  8. Mulch. Spread 5–7 cm of bark, compost or leaf mould over the root area, keeping it a few centimetres away from the stems.

Planting bare-root and root-balled shrubs

  • Bare-root: Keep the roots moist and plant as soon as possible. Soak the roots in water for an hour or so before planting. Dig a hole wide enough to spread the roots out naturally. Plant so the soil mark on the stem, which shows its original depth, is at soil level.
  • Root-balled (roots wrapped in hessian or netting): Set the plant in the hole, then loosen and fold back the wrapping. Remove any synthetic netting entirely, as it doesn’t rot.

Should you add compost or fertiliser to the hole?

Current advice, including from the RHS, is that for most shrubs on reasonable soil, it’s better not to add lots of compost or fertiliser to the planting hole. Backfill with the original soil instead and put organic matter on the surface as a mulch. Rich material in the hole can:

  • Encourage roots to stay in the hole rather than growing out into the surrounding soil.
  • Settle and decompose, so the plant sinks lower.
  • On clay, help create a waterlogged sump.

Mycorrhizal fungi products are optional. They may help some plants in poor or disturbed soils, but they aren’t essential in normal garden soil.

Fertiliser isn’t usually needed at planting. Feed later if growth is poor. See what and when to feed flowering shrubs.

Staking

Most shrubs don’t need staking. Tall or top-heavy shrubs in windy spots, and standards on a single stem, should be staked. Use a short stake and a flexible tie low down, so the stem can still move a little and strengthen. Remove the stake once the roots have established, usually after a year or two.

Watering and aftercare in the first year

Lack of water in the first year is the main reason newly planted shrubs fail.

  • First few weeks: Water every few days in dry weather.
  • First spring and summer: Water thoroughly once or twice a week in dry spells, and more often in hot weather or on sandy soil. A good soak that reaches the full depth of the root ball is better than a light daily sprinkle.
  • Second year: Water during prolonged dry spells.
  • Weeds: Keep the area weed-free so the shrub doesn’t compete for water.
  • Mulch: Top up the mulch each spring.

Shrubs planted in autumn usually need much less watering than spring-planted ones, but still check them during dry spells the following spring and summer.

Special cases

For a list of forgiving shrubs that establish easily, see our guide to easy flowering shrubs for every season.

The complete guide to flowering shrubs

Easy Garden Shrubs: Flowering Shrubs for Every Season
Read the guide

Keep exploring

Guides from other topics

All topics →