Evergreen Shrubs

How and When to Prune Evergreen Shrubs

Most evergreen shrubs are pruned in mid-spring or just after flowering. See timings by type, how to cut, clipping hedges, conifers and renovating old shrubs.

On this page
  1. Do evergreen shrubs need pruning?
  2. When to prune evergreen shrubs
  3. Pruning times by type of evergreen
  4. Tools for the job
  5. How to prune an evergreen shrub, step by step
  6. Heading cuts and thinning cuts
  7. Clipping hedges and topiary
  8. Lavender, heathers and other small shrubs
  9. Conifers and the “dead zone”
  10. Renovating an overgrown evergreen
  11. Watch out for nesting birds
  12. Common pruning mistakes

Do evergreen shrubs need pruning?

Many don’t need much. Most evergreen shrubs grow into a reasonable shape on their own, and plenty of slow growers, such as skimmia, sarcococca and osmanthus, may go years needing only the occasional stray shoot removed. Pruning is mainly for:

The single best way to cut down on pruning is to choose a shrub whose natural size fits the space. See our guide to choosing evergreen shrubs.

When to prune evergreen shrubs

The general rule in the UK is:

  • Prune most evergreens in mid-spring (around April to May), just as growth starts and after the worst frosts have passed. New shoots soon hide the cuts, and the plant has the whole season to recover.
  • Prune spring-flowering evergreens straight after flowering. Otherwise you cut off the flower buds.
  • Avoid hard pruning in late summer, autumn and winter. It can trigger soft new growth that’s damaged by frost, and cuts heal slowly in cold weather.

Formal hedges and topiary have their own timings (see below).

Pruning times by type of evergreen

Type Examples When How much
Winter- and spring-flowering evergreens Camellia, rhododendron, pieris, Daphne, Mahonia, Viburnum tinus, Berberis darwinii, Choisya, Osmanthus Straight after flowering Light. Remove unwanted shoots and deadhead where practical.
Summer- and autumn-flowering evergreens Escallonia, hebe, abelia, Fatsia, rosemary, Ceanothus (late-flowering types) Mid to late spring Light. Shorten untidy shoots.
Foliage evergreens Aucuba, Elaeagnus, Euonymus, Pittosporum, Photinia, laurels Mid-spring; light trims through summer if needed Light to moderate
Ground-cover evergreens Mahonia aquifolium, Hypericum calycinum Spring Can be cut back hard or sheared over in spring
Small, short-lived sub-shrubs Lavender, santolina, heathers, thyme After flowering (or early spring for some) Trim flowered shoots. Don’t cut into old, bare wood.
Formal hedges and topiary Box, yew, Lonicera nitida, privet, holly Late spring to late summer, depending on plant Regular clipping

For winter-flowering shrubs in particular, see our guide to winter-flowering shrubs.

Tools for the job

  • Secateurs: for stems up to about pencil or finger thickness
  • Loppers: for thicker stems, up to a few centimetres
  • Pruning saw: for anything thicker
  • Hand shears or hedge trimmer: for clipping small-leaved hedges and topiary
  • Gloves and eye protection: especially for holly, mahonia and berberis

Keep blades sharp and clean. Clean cuts heal better, and wiping blades between plants helps reduce the spread of diseases such as box blight.

How to prune an evergreen shrub, step by step

  1. Take out the dead, damaged and diseased growth first. Cut back to healthy wood, just above a bud, leaf or side shoot.
  2. Remove crossing and rubbing shoots, and any that spoil the shape or grow towards a path.
  3. Thin out congested growth where the centre is crowded, to let in light and air.
  4. Shape lightly. Shorten over-long shoots, cutting each back to a point inside the outline of the shrub so the cut is hidden.
  5. Step back and look often. It’s easy to take off more than you meant to.
  6. Don’t remove too much in one go. As a rough guide, the RHS suggests aiming to remove about a third of older wood in total when pruning established evergreens, except when deliberately renovating.
  7. Feed and mulch afterwards with a general-purpose fertiliser and a layer of compost or bark, and water in dry weather.

Large-leaved evergreens such as cherry laurel, Portugal laurel, aucuba and rhododendron are best pruned with secateurs, cutting individual stems. Hedge trimmers slice through the big leaves, and the cut leaves brown and look unsightly for months.

Heading cuts and thinning cuts

Two kinds of cut produce quite different results:

  • Heading cuts shorten a shoot back to a bud or side shoot. This stimulates several buds below the cut to grow, making the plant bushier. It’s how hedges and clipped shapes thicken up.
  • Thinning cuts remove a whole shoot back to where it joins a larger branch, or to the base. These cause much less regrowth. They’re the best way to reduce size while keeping a natural, informal shape.

For most informal evergreen shrubs, a mix of a few thinning cuts and some light heading back gives the most natural result. Shearing an informal shrub all over into a dome tends to create a dense outer shell of leaves with bare stems inside.

Clipping hedges and topiary

  • Box: usually clipped once a year in late spring or early summer, after the first flush of new growth, with a second light trim in late summer if needed. Clip in dry weather, disinfect tools and clear up clippings. These steps help reduce the risk of box blight.
  • Yew: usually trimmed once a year in late summer, which keeps it neat through winter.
  • Lonicera nitida and privet: fast-growing. They may need clipping two or three times between late spring and late summer.
  • Holly, Portugal laurel and other informal evergreen hedges: usually once a year in late summer, using secateurs on large-leaved types.

Whatever the hedge, keep it slightly narrower at the top than at the base. That lets light reach the lower branches and helps stop the hedge going bare at the bottom.

Lavender, heathers and other small shrubs

Lavender, santolina, heathers and similar small evergreens are relatively short-lived and tend to become woody and sprawling if left unpruned. Unlike many shrubs, they don’t usually regrow from old, bare wood.

  • Lavender: trim after flowering in late summer, cutting off the flower stalks and a little of the leafy growth. Always leave some green leaves on every stem. Don’t cut into the bare wood below.
  • Heathers: trim off faded flowers after flowering, just below the flower spikes.
  • Santolina and curry plant: trim lightly in spring to keep them compact.

Even with good care, these plants often need replacing after several years. Our list of small evergreen shrubs suggests compact alternatives.

Conifers and the “dead zone”

Because evergreens keep their leaves, the outer layer shades the inside of the plant. Inner branches often lose their leaves and, in most conifers, stop producing new buds. This bare inner area is sometimes called the “dead zone”. It isn’t actually dead, but if you cut back into it there are no buds to regrow.

  • Leylandii, Lawson cypress, thuja and juniper: trim only within the green, leafy growth. Cutting into bare, brown wood usually leaves a permanent gap.
  • Pines: pinch or shorten the soft new “candles” in late spring to keep them compact. Don’t cut into old wood.
  • Yew: the exception. It regrows readily from old wood, and can even be cut back hard to the main trunk to renovate.

If a conifer has already browned, see why evergreen shrub leaves turn brown.

Renovating an overgrown evergreen

Old, overgrown shrubs can often be rejuvenated:

  • Shrubs that usually tolerate severe pruning to near ground level in mid-spring include spotted laurel (Aucuba), box, camellia, choisya, euonymus, holly, pieris, cherry laurel and Portugal laurel, Viburnum tinus and yew (RHS guidance).
  • Other evergreens are safer renovated over two or three years. In the first year, remove a third to half of the oldest stems at ground level and shorten the rest by about a third. Then, in each of the next couple of years, remove half of the remaining older shoots.

After renovation, feed, mulch and water well through the following spring and summer. Expect few flowers for a year or two. For a detailed worked example, see can I cut my viburnum to the ground?

Watch out for nesting birds

Evergreen shrubs and hedges are favourite nesting sites. In the UK it’s an offence under the Wildlife and Countryside Act 1981 to intentionally damage or destroy an active wild bird’s nest. The main nesting season runs roughly from March to August, though nests can be found outside that period. Always check carefully before pruning or clipping. If you find an active nest, wait until the young have fledged.

Common pruning mistakes

  • Pruning spring-flowerers in winter, which removes that year’s flowers
  • Hard pruning in autumn, which leaves soft regrowth vulnerable to frost
  • Cutting conifers into bare wood, which leaves permanent holes (yew aside)
  • Shearing large-leaved shrubs, which leaves browning, half-cut leaves
  • Removing too much at once from shrubs that don’t tolerate it
  • Using blunt or dirty tools, which tear stems and can spread disease
  • Pruning instead of moving. If a shrub always outgrows its spot, a smaller variety may be the better answer.

The complete guide to evergreen shrubs

Evergreen Shrubs: How to Choose the Best for Your Garden
Read the guide

Keep exploring

Guides from other topics

All topics →